RG 65
50 topics in this forum
-
- 0 replies
- 2,087 views
-
- 1 reply
- 232 views
-
- 0 replies
- 277 views
-
- 0 replies
- 159 views
-
- 0 replies
- 116 views
-
- 0 replies
- 113 views
-
- 1 reply
- 390 views
-
- 0 replies
- 204 views
-
- 1 reply
- 553 views
-
- 0 replies
- 387 views
-
- 0 replies
- 349 views
-
- 0 replies
- 493 views
-
- 0 replies
- 385 views
-
- 0 replies
- 376 views
-
- 0 replies
- 664 views
-
- 0 replies
- 497 views
-
- 3 replies
- 1,289 views
-
- 4 replies
- 1,537 views
-
- 1 reply
- 863 views
-
- 0 replies
- 798 views
-
- 2 replies
- 1,134 views
-
- 0 replies
- 695 views
-
- 2 replies
- 1,356 views
-
- 0 replies
- 808 views
-
- 0 replies
- 801 views
-
Who's Online 2 Members, 0 Anonymous, 11 Guests (See full list)
-
Recent Topics
-
-
Recent Posts
-
Perhaps replace with new then. Its reusable, adaptable and will conform to whatever shape you need. Also make sure you key/scuff the outside of the new pot before sealing it in to allow the sealant to bite into it. Sounds obvious, but i found my one had been previously installed as a lovely shiny new pot. Subsequently the adhesive didnt stick for long. Another good tip is to screw it to the hull from inside, as this helps provide additional supprt to cope with the torque of regularly tightening the pot lid. -
Thanks for that Frayz. Part of my problem was that the holes had blu tac but it was so dried up that most of it had fallen out! -
I have tried putting the hull in our pond with the keel weight in approximately the correct position. The water line came up to less than 10 mm above the bottom of the stem and just on the bottom edge of the transom. On this basis I think the weight will probably be OK after all, provided I fix it in the correct location longitudinally on the centreline. However any advice would be gratefully received. Gareth
-
-
Forum Statistics
-
Total Topics909
-
Total Posts4,086
-
-
Member Statistics
