Jump to content
    • MYA Forums
      • Forum Rules
      • General Discussion
      • Racing Rules
      • Events
      • MYA Chat
      • Commercial
    • Class Chat
      • IOM
      • DF Racing
      • Marblehead
      • 6 Metre
      • RG 65
      • A Class
      • 10 Rater
      • 36"
      • Footy
      • Free Sailing
    • Classified Ads
      • Classifieds Terms and Conditions of Use
      • For Sale
      • Wanted
      • Anything else
    • Off Topic Discussions
      • The Boat House
      • Issue Reporting
      • Forum Development
  • Recent Topics

  • Recent Posts

    • Perhaps replace with new then. Its reusable, adaptable and will conform to whatever shape you need. Also make sure you key/scuff the outside of the new pot before sealing it in to allow the sealant to bite into it. Sounds obvious, but i found my one had been previously installed as a lovely shiny new pot. Subsequently the adhesive didnt stick for long.  Another good tip is to screw it to the hull from inside, as this helps provide additional supprt to cope with the torque of regularly tightening the pot lid.
    • Thanks for that Frayz.  Part of my problem was that the holes had blu tac but it was so dried up that most of it had fallen out!
    • I have tried putting the hull in our pond with the keel weight in approximately the correct position.  The water line came up to less than 10 mm above the bottom of the stem and just on the bottom edge of the transom.  On this basis I think the weight will probably be OK after all, provided I fix it in the correct location longitudinally on the centreline.  However any advice would be gratefully received. Gareth
  • Forum Statistics

    • Total Topics
      909
    • Total Posts
      4,086
  • Member Statistics

    • Total Members
      601
    • Most Online
      48

    Newest Member
    Sealine
    Joined
×
×
  • Create New...